Utility Water Pumps

hot water dispensers

Irving’s Plumbing distributes utility water pumps for a variety of tasks including everything from powering a waterfall to draining low lying flooded areas. Our utility pumps run on electricity and are typically used for moving water or liquid materials between containers, draining hot water tanks, irrigation, and other similar activities. We offer two rugged utility pumps that are designed to move effluents, semisolids, and small solids in a variety of residential, commercial and industrial applications.
We offer the following three models from Liberty Pumps: 331 Series | 260 Series




The LP331 portable utility pump is mostly used as a transfer pump for general water transfer projects. It can also be used for increasing your water pressure or draining your hot water tank The main features of this pump include a one-piece cast aluminum pump and motor housing with integral carry handle, permanently lubricated bearings, a convenient On/Off switch, and a powerful ½ hp motor capable of pumping to over 100 feet of head. Please note that this utility pump is not designed for permanent installations or long, extended periods of continuous operation. It is used for portable, temporary applications only. Easily accessible motor brushes are replaced in minutes with just a screwdriver. They require replacement every 100-200 hours of operation.
Main Features

  • Pump Housing: One-piece, corrosion-resistant cast aluminum.
  • Impeller: Glass reinforced thermoplastic with molded brass nut.
  • Ball Bearings: Permanently lubricated, maintenance free.
  • Motor: 1/2 hp, 115V AC, 8 amps, 60 HZ, 7500 RPM.
  • Power Cord: 20′ heavy-duty, with ground.


  • Water Transfer
  • Draining Hot Water Tanks
  • Boosting Water Pressure by 40 lbs.

Weight: 10.5 lbs.
Height: 7″
Major Width: 4 1/2″
Length: 9 3/4″
Maximum Fluid Temperature – 135° F


Lightweight and easy to carry around, this submersible utility pump is perfect for those light water transfer projects around the home or on an industrial construction site. It can be used for draining water from your pool covers, from flooded areas around your building or on a construction site. Completely submersible and powered by a 1/6 horse power motor, this utility pump can pump down as low as 1/8 of an inch.
Main Features

  • Pump Housing: Thermoplastic body that resists impact, stress, and corrosion.
  • Impeller: self-cleaning trash-type impeller.
  • Motor: 1/6 hp 115 volt, 2 amp air cooled PSC motor.
  • Power Cord: 8′
  • Shaft seal and lip seal.
  • Thermal overload protection.
  • Pumps down to 1/8″.
  • Completely submersible.
  • Removable bottom screen for easy cleaning.
  • Portable – weighs only 7.5 lbs.
  • 3/4″ garden hose connections.


  • Pumping pool covers
  • Irrigation
  • Powering a waterfall
  • Pumping flooded areas

Weight: 7.5 lbs.
Height: 9.5″
Width: 7″

Leave a Reply

Your email address will not be published. Required fields are marked *